How to make your own Standalone Arduino

//How to make your own Standalone Arduino

Let’s make our own Standalone Arduino


Once you have your project working on a Arduino UNO and would like to make it permanent without sacrificing your Arduino UNO development board, it’s a good idea to just take the ATmega328 chip out and embed it on a breadboard or PCB.

Making your own Standalone Arduino is not just about saving money it’s also about using less power since you decide what components to include.

In this tutorial we will build 2 versions, one using the standard LM7805 voltage regulator and an other using a miniature switching power supply board.

Note:  There are many different ways to build a standalone Arduino, this tutorial is meant to show you 2 ways to achieve this.


Here are the parts used in both version :

10uf electrolytic capacitors, 22pf ceramic capacitors

10K and 220Ohms resistors

16MHz crystal, tact switch and 3mm LED

As you can see in the schematic above, we are using the popular LM7805 to regulate the power down to 5V.

The LM7805 is not the most efficient (approx. 55%), but if your project is connected to the grid, than this doesn’t really matter.

Now in this schematic we are using a more efficient (up to 96%) miniature switching power supply.

If using batteries this would save power and make your project last longer.

Also it requires less connections since all the component are included on the switching board, unlike the LM7805 that requires capacitors and jumpers.

We are using 2x 18650 Protected batteries of 3.7V and 4500mAh each.

Connected in series they will provide between 7.4 – 8.4V and have a capacity of 4500mAh.

Using Protected 18650 batteries is important to make sure that they don’t get over-discharged.


As you can see the Arduino UNO board on its own uses quite a bit of power, so building a standalone Arduino UNO makes sense once you have your project working and want to power it using batteries.

Many thing will influence the runtime:  number of sensors, Led’s, update intervals, etc… but using an efficient power regulator will save power that would have been lost otherwise, and for about 1 dollar more compared to using the LM7805, it kinda of makes sense.

Also keep in mind that there are many other ways to build a Standalone Arduino UNO, so as we always say:

Get Learning, and build your own,  “Your” way!

By | 2018-02-23T17:20:53-05:00 March 22nd, 2015|Tutorials|


  1. Steven Nelson July 30, 2019 at 9:40 am - Reply

    Thank you Just the info I needed

  2. Nikos April 11, 2018 at 9:55 am - Reply

    Hello, whats the name of the part? LM2596?

    • Laura Fegely January 30, 2019 at 10:25 am - Reply

      I was curious too, and after googling ‘miniature switching power supply D-SUN’, I found what appears to be multiple makers of these boards (available from amazon and other places). It looks like they use the MP1584 buck switching regulator. Hope this helps!

      • Steven Nelson July 30, 2019 at 9:38 am - Reply

        Thank you Good Sure

  3. Jordan M De Sotle February 28, 2018 at 10:56 pm - Reply

    Hi. I have been trying to make my Arduino Uno standalone for a couple days with no luck. Is it possible I could get the schematic? I am missing some of the parts you have so it would be easier to download it. Nice tutorial. Hopefully I can get this working with the right parts

Leave A Comment